Cabletron Systems SmartSwitch 6C110 Installation Instructions Manual
9033011
Page 1 of 7
6C110 POWER BRIDGE ADAPTER
INSTALLATION INSTRUCTIONS
This upgrade kit contains the power bridge adapter that, when properly installed, allows the 6C110 chassis to
support the 6C210-1 and 6C210-2 power supplies.
Required Tools
The following tools are required to install the 6C110 power bridge adapter:
•
ESD wrist strap
•
Phillips head screwdriver
•
Flat head screwdriver
•
Hex nut driver (.25-inch)
Equipment Checklist
Ensure the upgrade kit contains the following items before proceeding with the installation. If any components are
missing, contact Cabletron Systems. Information on contacting Cabletron Systems is available at the end of this
document.
•
Power Bridge Adapter (1)
•
Standoffs (3)
•
Support Clip (1)
•
Blank Faceplate (1)
Related Manuals
Use the
6C110 Overview and Setup Guide
to supplement the procedures and other technical data provided in this
manual:
This manual can be obtained on the World Wide Web in Adobe Acrobat Portable Document Format (PDF) at the
following site:
http://www.cabletron.com/
Only qualified personnel should perform the following installation procedures.