CAD Audio WX1200 Manual And Quick Start-up Manual - page 3
3
6
Operating Instructions
• Insert new high-quality alkaline AA batteries into your transmitter,
observing proper direction.
• Power up the receiver and transmitter.
• Scan-Link
TM
your system by pressing the Set/Scan button on the
receiver to automatically select operating channel.
•
IR node in alignment with the receiver IR node within a distance
of approximately 12". The receiver will automatically set the
is “Scan-Link’d.”
• To set up additional units continue the sequence while keeping
previously linked transmitters away from the receiver that is
attempting to Scan-Link
TM
.
Receiver RX1200 (Front)
• Set/Scan button – Scan-Link
TM
operation
• IR Node – Scan-Link
TM
communication
• Antenna A and antenna B
• AF Peak indicator LED
• Channel display
• Diversity indicator LED
• Select button – manual selection of receiver channel
Bodypack TX1210 Transmitter
• IR Node for Scan-Link
TM
operation
• 4 pin connector (TB4M-type)
• 3 Color LED indicator
- Green = Transmitter is powered up
and audio is live
- Orange = Transmitter is powered up
and audio is muted
- Flashing Red
= Low battery status
(change battery ASAP)
• Power Switch – Soft touch switch
- Holding the switch for 2 seconds turns
the transmitter on/off
- Quick momentary press of the switch
mutes or unmutes the audio
• Volume control
Frequency Response
................................................................
40Hz – 15KHz
Maximum Input Level
Microphone Input: .................................................................
-18dBV
Instrument Input: .....................................................................
-6dBV
RF Output ...........................................................................................
<50mW
Dimensions ..............................................
2-9/16" [6.5cm] x 4 -1/4" [10.8cm]
x 15/16" [2.3cm]
Net Weight ....................................................................................
2.8oz [82g]
Power Requirements ............................................................
2x AA batteries
Battery Life ....................................
>=10hrs, high-quality alkaline batteries
Interfacing to TX1210 input connector
3k3
3k3
3k3
3k3
3-wire type electret mic
Dynamic mic
2-wire type electret mic
Instrument