CAD Audio WX1200 Manual And Quick Start-up Manual - page 4
4
5
Receiver RX1200 (Rear)
• 1/4" unbalanced output
• Volume control
• Squelch adjustment
(factory preset – do not adjust without factory support )
• XLR-type balanced output
• DC power jack (use included power supply)
Maximum Output Level
Balanced Output ..............................................................................
-16dBV
Unbalanced Output .........................................................................
-13dBV
Output Impedance
Balanced Output ..........................................................................
350ohms
Unbalanced Output .....................................................................
250ohms
Switchable Channels
..................................................................................
16
Dimensions ..............................................
9-1/2" [23.0cm] x 4 -1/2" [11.4cm]
x 1-9/16" [4.0cm]
Weight ........................................................................................
12.3oz [350g]
Power requirements ....................................................
12-15VDC, =<500mA
Handheld TX1200 Transmitter
• Power Switch – Soft touch switch
- Holding the switch for 2 seconds turns the transmitter
on or off
- Quick momentary press of the switch mutes or unmutes
the audio
• Tri-color LED indicator
- Green = transmitter is powered up and audio is live
- Orange = transmitter is powered up and audio is muted
- Flashing Red
= low battery status (change battery ASAP)
• IR node for Scan-Link
TM
operation
Microphone Operating Principal
...............................
Moving coil dynamic
Polar Pattern .....................................................................................
Cardioid
Frequency Response
...............................................................
40Hz – 15KHz
Maximum SPL ......................................................................................
143dB
Dynamic Range .....................................................................................
110dB
RF Output ...........................................................................................
<50mW
Dimensions ................................................
9-1/2" [24.1cm] x 1-7/8" [4.8cm]
Net Weight ...................................................................................
7.3oz [208g]
Power requirements .............................................................
2x AA batteries
Battery Life ....................................
>=10hrs, high-quality alkaline batteries
5
Soft-touch
power
switch
Tri-color LED
indicator
IR node for
Scan-Link
TM
operation