Cadac Maestro 3B User Instructions - page 12
20
21
Figure 4.2
Figure 4.1
17. ASSEMBly PROCEDURE
Figure 1
•
Place the BBQ unit, lying on its back, on a flat, level surface.
•
Align the spacer with the corresponding holes on the leg.
•
Fasten leg & spacer to BBQ body using M6x70mm screws supplied.
•
Do not tighten screws.
•
Repeat the above for the remaining legs.
Figure 2
•
Fit the bottom panel to the frame by aligning the holes in the bottom panel with the holes on the legs, secure in position
using the M6x12mm screws supplied.
•
Do not tighten the screws.
Figure 3
•
Fit the small castor wheels to the frame aligning the threaded stud on the wheel with the hole underneath the leg. Screw
the wheel into the leg. Fasten securely.
•
Push the axle through the wheel and align with the corresponding hole on the leg. Fasten the wheel to the frame using
the M10 nut supplied. Fasten securely.
•
Fit the hub cap by clipping it onto the wheel.
Figure 4
4.1 Fit the cylinder hook to the BBQ body using the M6x12mm screws and M6 nuts supplied.
4.2 Fit the cylinder support to the frame using the M5x10mm screws supplied.
Figure 1
Figure 2
Figure 3
ASSEMBLY INSTRUCTIONS for Maestro 4B / 98324S, Maestro 3B / 98323S and Patio 3 Essence / 98335S.
Figure 6
Figure 7
Figure 8
Figure 5
•
Turn the unit upright and place it on a flat surface.
•
Fit the front panel to the frame by aligning the holes in the front panel with the holes on the inside face of the front legs
and secure in position using the M5x10mm screws supplied.
•
level the unit out and fasten all screws securely.
Figure 6
6.1 Fit side tray to the frame using the M6x12mm screws supplied.
•
Fasten all screws securely.
•
Repeat the process for both trays
Figure 7
•
Fit the drip tray by sliding it into the BBQ unit from the rear.
•
Fit the oil cup to the drip tray by sliding it into the bracket situated underneath the drip tray.
Figure 8
•
Place a flame tamer over each burner.
•
Fit the grill plate / griddle plate by placing it inside the BBQ body.
•
Fit the warming rack to the locators situated inside the BBQ body.
Figure 5