Cadac Waves Tracks Live Quick Reference Manual - page 11
Page 11 of 19
DOC02-Using Waves Tracks Live - Issue C - July 2016
From the main screen, select ‘Audio’ then ‘SoundGrid Inventory’. The following screen should
appear with several devices listed.
Adjust the assign buttons till the correct three are assigned as shown below:
This screen is the key place to spot if everything is correctly connected and running properly.
There should be no
Red
on the screen.
Note: IO: Cadac SP6 represents the CDC six Waves I/O and should have 64 channels.
DRV: SG Driver this represents the audio networks visible in the system. There may be two of these
shown, one for the console and one for the computer. However, ONLY the external computer one
should be assigned. It will have a MAC address / handle related to the computer and should become
‘N/A’ when the Ethernet cable is disconnected or ‘Tracks’ is not running.
Select so it has 64 channels.
MR: MultiRack This represent the MultiRack program itself.
Be aware that firmware error screens can occur. This usually means the server or the console’s I/O
firmware is out of date compared to the MultiRack software on the console. The cure for this is to
select the appropriate UPDATE button which will load new firmware into the hardware.