Cadero CB6-SBG001-A User Manual - Igniter Check
16
IGNITER CHECK
Turn gas off at LP tank. Press and hold electronic igniter button. A click should be heard and a spark
seen each time between burner and electrodes. See Troubleshooting section if there is no click or
spark.
VALVE CHECK
Important: Make sure gas is off at LP tank before checking valves, and knobs are in Off position. To
check valves, first push in knobs and release, knobs should spring back. If knobs DO NOT spring
back, replace valve assembly before using grill. Turn knobs to Low position then turn back back to Off
position. Valves should turn smoothly.
HOSE CHECK
Before each use, check to see if hoses are cut or worn. Replace damaged hose before using grill. Use
only valve/hose/regulator specified by manufacturer.
Keep fuel supply hose away from any heated surfaces.
GENERAL GRILL CLEANING
Unit should be turned off and cool to clean.
DO NOT
mistake brown or black accumulation of
grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should NEVER
be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on
insides of grill lid and bottom. Rinse and allow to completely air dry.
DO NOT
apply a caustic
grill/oven cleaner to surfaces.
Plastic parts: Wash with warm soapy water and wipe dry.
DO NOT
use abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage
to and failure of parts can result.
Porcelain surfaces: Because of glass-like composition, most residue can be wiped away with baking
soda/water solution or specially formulated cleaner. Use non-abrasive scouring powder for stubborn
stains.
Painted surfaces: Wash with mild detergent or non-abrasive cleaner and warm soapy water. Wipe
dry with a soft non-abrasive cloth.
Stainless steel surfacess: To maintain your grill’s high quality appearance, wash with mild detergent
and warm soapy water and wipe dry with a soft non-abrasive cloth after each use.