Caesar Fireplace CHFP-102A Installation And Operating Instructions Manual - 7.0 Operating Instructions

Summary of CHFP-102A

  • Page 1

    Certified under canadian and american national standards: etl chfp-30a electric fireplace installation and operating instructions hot glass will cause burns. Do not touch glass until cooled. Never allow children to touch glass. ! Warning installer: leave this manual with the appliance. Consumer: ret...

  • Page 2: Table of Contents

    2 note: changes, other than editorial, are denoted by a vertical line in the margin. Table of contents 1.0 packing list 2.0 3.0 introduction 3.1 dimensions 3.2 listing approvals 3.3 general instructions 4.0 placing appliance 4.1 unpacking and testing appliance 4.2 grounding appliance 5.0 installatio...

  • Page 3: 1.0 Packing List

    1.0 packing list no description quantity 1 electric fireplace 1 pc 2 installation and operating instructions 1 pc 3 remote control (battery included) 1 pc 4 media bed kit (falling stars) 1 box 5 wall mount bracket 1 pc 6 wall anchors 7 sets 1 2 3 3 6 4 5.

  • Page 4: 3.0 Introduction

    3.0 introduction ! Warning this appliance is hot when operated and can cause severe burns if touched. Do not operate appliance before reading and understanding operating instructions. Failure to operate appliance according to operating instructions could cause fire or injury. Risk of burns. Power to...

  • Page 5

    3.1 dimensions 3.2 listing approvals this appliance has been tested in accordance with the etl standards for fixed and location-dedicated electric room appliances in the united states and canada. If you need assistance during installation, please contact your local dealer. Note: this appliance must ...

  • Page 6: Warning

    3.3 general instructions this electric appliance meets the construction and safety standards of h u d for application in manufactured . . . . Homes when installed according to these instructions ! Warning read these instructions completely before beginning installation failure to . Follow them could...

  • Page 7: Warning

    ! Warning 4.0 placing appliance 4.2 grounding appliance never place this electric appliance where it may fall into a bathtub or other water container. Wear safety gloves and safety glasses for protection during installation and maintenance. To prevent contact with sagging or loose insulation the ele...

  • Page 8: 5.0 Installation

    5.0 installation ! Warning risk of fire! The power cord must not be pinched against a sharp edge secure cord to avoid . Tripping or snagging to reduce the risk of fire electric shock or personal injury. Do not run , cord under carpeting. Do not cover cord with throw rugs runners, etc arrange cord , ...

  • Page 9

    5.1 wall-mount installation side view 16-3/4 (423mm) " 6-3/4 (171mm) " hooks wall mount bracket slots rear view d ue to the many different materials used on different walls, it is highly recommended that you consult your local builder before you install this appliance on the wall. Power line screw×3...

  • Page 10

    Side view 5.3 free standing installation (option) a fix the pillar and plate with 4 screws, as shown in the figure (a). B upend the box, then fix it and base with 4 screws at the bottom of the box, as shown in the figure (b). C. Fix another two plates and base with 4 screws. Base installation is fin...

  • Page 11: 6.0 Finishing

    Openings, operation of doors or access for service. Observe 6 1 glass door removal . Data line power line 6.0 finishing 11 a. B. To d plastic connector plastic connector c. Remove the glass door from appliance. Two people to hold the glass door and lift the door until it’s out of the holes. Isconnec...

  • Page 12

    6 2 media bed kits installation . Note: glass front must be removed and the appliance must be finished in its final location before the media bed kits are installed. Media bed kits may have sharp edges, wear safety glasses and gloves when handling. Carefully place media bed kits into the bottom tray...

  • Page 13: 7.0 Operating Instructions

    7.1 main power button once the appliance has been plugged into a grounded electrical outlet, it is ready to operate. The main power button is located on the right of the control panel as illustrated. Press this button to turn on the appliance. Press again, the button will bounce back, the appliance ...

  • Page 14

    14 7.2.2 remote operation make certain that new batteries are installed correctly and the appliance turned on! The remote control will not work if the main power switch is not pressed down. When operating the remote control, it must be directed towards the right of the appliance. Note: a. Plug in yo...

  • Page 15

    7.3 panel control panel control is the same as remote control. G. To change flame speed, press the speed button. There are 5 speeds to choose from. " " the show "v1" to "v5" when pressing this button. Indicator will j. Turnontheappliance, all the backlight willbelightedup. Do not press any button fo...

  • Page 16: 8.0 Maintenance

    8.0 maintenance ! Warning disconnect power and allow heater to cool before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to person. The fireplace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build up ...

  • Page 17: 9.0 Replacement Parts

    Main power button reflector 11 12 chp-001 chp-002 chp-003 chp-004 chp-005 chp-006 chp-007 chp-008 chp-009 chp-010 chp-011 chp-012 17 1 2 3 4 5 6 7 8 9 10 11 12 13 13 chp-013 stand 9.0 replacement parts 626-328-6324.

  • Page 18: 10.0 Warranty

    10.0 warranty 18 caesar fireplace ® electric appliances are manufactured under the strict standard of the world recognized iso 9001:2008 quality assurance certificate. Caesar fireplace who take great pride in their work. Once assembled the complete appliance is thoroughly inspected by a qualified te...