Caesar Fireplace CHFP-102A Installation And Operating Instructions Manual - page 15
7.3 PANEL CONTROL
Panel control is the same as remote control.
G. To change flame speed, press the SPEED
button. There are 5 speeds to choose from.
"
"
The
show "V1" to "V5" when pressing this button.
indicator will
J.
turnontheappliance, all
the backlight willbelightedup. Do not press any button for 20 seconds, all
the backlight will
be off.
When you
K. Pressthe"ON/OFF" buttomtoturnofftheappliance.
I.
Press"TIMER" button, thissetsthetimingforswitchingthefireplaceoffautomatically. The timer
rangesfrom1to8hours, whichwillbeshownonthe indicatorfrom"1H"to"8H". Timeris turned off when the
indicatorshows"0H". Iftheapplianceis restarted, timeralsoneedstobereset again.
NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be effective and this
range may be reduced as the battery power is depleted.
H.
to activate the heater press the HEAT
button. The initial set-up heat level will be
set for low heat 750W ,
"-". To adjust the heat level press again for high heat
(1500W ,
"--".Press it for the third time, then the mechanism will stop function. After 10 seconds,
"
".
Under
the unlock mode
the
indicator will show
indicator willshow
the indicator
will
show 0F
,
,
"
"
(
)
) the
15