Cafe Elite 5151 Installation Manual - page 6
Connections
Components supplied with unit
1.
Drain hose, 7’ X 3/4” Dia.
2. Water inlet hose, metallic
flex hose 5’ w/ 3/8” female
connections both ends.
3. 5ft. power cord w/ NEMA
type 6-30P plug.
3
1. Water drain
2. Water supply
3. Electrical connection
* Place drain hose into
l
Water supply, 3/8”
*
Power supply recept.
drain loosely (Air Gap)
male straight pipe.
NEMA 6-30P
* Drain pipe min 1 in. dia.
l
Flowing water press-
+ Air gap provides req-
ure of 15.5 to 115 PSI
uired vacuum breaker.
6.
Electrical connection
*
Connection and initial start-up of machine must be performed by a qualified
and trained Cafe Elite technician.
*
Connections must comply with National, State and Local Codes.
*
Refer to
data
plate on machine to confirm all specifications are met when
hooking up inlet supplies.
*
Machine is supplied with a 5ft. cord & NEMA 6-30P plug, do not alter the
plug in any way, connect to single phase supply only with earth ground and a
2 pole 30 Amp. circuit breaker. Use a minimum of 10 AWG wire for the
supply lines. An optional ground screw is provided on the bottom rear of the
machine.
5