Cafina Coffee Center c60 Operating Instructions Manual - page 3
-3-
CONNECTION AND INSTALLATION
All Cafina machines are supplied ready for connection. Before a machine can be
installed, however, the service outlets and the drain must be prepared (according to the
connections diagram) and be located within 1 m.
This work must be carried out by appropriately qualified personnel and be in strict
accordance with the applicable regulations. The Cafina service department is not
authorised to install the service outlets or the drain and can accept no responsibility
for them.
The machine must be placed on a solid table top or counter surface. A hole with a
diameter of 120 mm must be drilled in the surface for the connections as shown in the
connections diagram.
Please do not install the machine in large catering kitchens. It is has not been
designed for that kind of operation.
a) Electrical connection
The power supply voltage must agree with
the data on the nameplate. The supply must
be separately fused in accordance with
local regulations. A power point outlet is
preferred. However, where the connection is
directly terminated at junction box, a switch
must be provided which breaks all poles and
has a contact gap when open of at least
3 mm.
b) Water supply
A stop-cock with a back-pressure valve must be installed in an easily accessible position.
A water filter (option) should be fitted where the local conditions require it. The filter must
be mounted vertically. Water supply and drain hoses are provided with the machine. The
hoses must not be shortened during installation for safety reasons. The steady-state
water pressure must be at least 2 bar. A pressure reduction valve must be included
between the stop-cock and the machine where the water pressure exceeds 5 bar.
Before using the machine for the first time, any water filter fitted must be activated as
directed in the
specific instructions (Brita
®
= 3 min, Everpure
®
= 5 min). The activation
procedure must be repeated whenever the filter element is replaced.
c) Water drain
All machines are equipped with a drain outlet to which the hose supplied can be fitted.
The hose is inserted into an open drain pipe.