Caidrox HD-2000 User Manual - page 9
9
2) Image recording in an event
mode setting
When the Product detects a shock of more than the regular value, the images
before and after the event occurs will be recorded. The storing time of image before
and after the event occurs can be set arbitrarily by the user within the range from
10 seconds (min.) to 30 seconds (max.).
3) Image recording by the emergency REC function
The emergency REC function is available only when the event mode is set. By
pressing the Emergency REC Button, the image before and after pressing the
button can be recorded. The time of recording can be set arbitrarily by the user
within the range from 10 seconds (min.) to 30 seconds (max.).
.
6. Blue LED will flash on after receipt of GPS (a few seconds ~a few minutes).
※
applied only to the products with GPS built in (HD-2000).
7. All the features of the Product operate normally.
* If there is not enough storage space for the recorded image, it is recorded in
sequential order. Therefore, the images which you need to keep permanently had
better be saved in your PC separately.
- Stopping the operation of the Product
When the engine of the vehicle is stopped, the main body of the Product is also
powered off.
Follow the steps below to remove the SD Memory Card.
1. Turn off the engine of the vehicle, and make sure that the start up key is pulled
out of the vehicle.
2. When the operation of the Product is stopped, both red LED and blue LED will be
turned off after the beep sounds five times. LED light fades away slowly.
3. When all LEDs are turned off normally, remove the SD Memory Card.
* If you remove the SD Memory Card before the operation of the Product is
stopped, an error can occur in the recorded images. Remove the SD Memory Card
after the operation of the Product is completely stopped.