Cal Amp LMU-26xx Install Manual - page 20
CalAmp | LMU-26xx Install Guide
Page 14
MBUD-0199v3.3
5. Route the power cable to the source of 12 Volts continuous and 12 Volts ignition switched.
Refer to
Section 5.2: Install Power Connections
for detailed instructions on installing the
power cable.
6. Carefully remove any panels required for access as needed. Ensure there are no sharp edges
that may abrade the wire. Use a suitable means to protect the cable from the sharp edge to
eliminate possible wear or reroute the wire if possible.
7. If applicable, connect Buzzer and/or Switch with LED Cables.
Refer to Section
5.3: Optional Buzzer Assembly Cable
instructions and/or
Section 5.4:
Optional Switch with LED Cable
instructions.
8. If applicable, route the I/O Cable to the source of the I/O signals.
Refer to
Section 5.5: Connect Optional Inputs
for detailed instructions on installing the I/O
Cable.
9. If applicable, connect the optional serial cables (e.g., NMEA or Garmin).
Refer to Section
5.6: Install Optional Serial Cables
for detailed instructions on install the
serial cables.
10. Follow the steps outlined in
Section 5.5: Verify LMU-26xx Operations
to verify successful
installation.