Cal Amp LMU-26xx Install Manual - page 35
CalAmp | LMU-26xx Install Guide
MBUD-0199v3.3
Page 29
Figure 33: Connect jPOD Cable and jPOD Adapter Using Serial Connector
3. Detach the vehicle’s existing Jbus port by removing the retaining screws (save screws for next
step). If the vehicle has a 6 pin DIN connector, either use the 8973002002 Y cable instead of the
5C909-2 9 pin Jbus cable, OR use the 6 pin to 9 pin adapter cable 8973002001.
4. Using the retaining screws, attach the jPOD Adapter in place of the vehicle’s Jbus port.
5. Plug the Jbus male connector of the jPOD Cable into the jPOD Adapter seated in the vehicle’s OBD-II
port.
6. Connect the jPOD Cable to the serial connector of the jPOD Adapter.
7. Ensure that all cables are secured with proper connections to the components. Coil and secure loose
or excess cable, and ensure it is out of the way of normal vehicle operations. Verify that cables are
not stretched and do not rub on vehicle components, which could cause unexpected wear.
8. If using the Buzzer and JPOD with the 5C260 harness you must connect the Red and White wires
together.
LMU-26xx with 5C261 Cable and jPOD Assembly LMU-26xx with 5C260 Cable and jPOD Assembly
Figure 34: LMU-26xx and jPOD Assembly
Connect Red &
White Wire
Together of 5C260
Aux 2
Aux 2