Calculated Industries Machinist Calc 4086 User Manual - 4 — M

4 — M

achinist

 c

alc™

/ M

achinist

 c

alc™

 P

ro

    Changing a U.S. Thread Classification

 ..................................................... 46

    Changing a Metric Thread Classification

 .................................................. 46

    Numeric Thread Size – 

Model 4087

 ......................................................... 47

    Fractional Thread Size – 

Model 4087

 ....................................................... 48

    Metric Thread Size – 

Model 4087

 ............................................................. 50

    Custom Thread Percentage 

(NOT AVAILABLE ON MODEL 4086)

 ........................... 51

  WIRE SIZES AND 3-WIRE MEASUREMENTS 

(NOT AVAILABLE ON MODEL 4086)

 ........................................................................... 52

    Wire Size

 ................................................................................................... 52

    3-Wire Measurement – 

Known Thread Size and Wire Size

 ..................... 52

    Pitch Diameter – 

Known 3-Wire Measurement and Wire Size

 .................

53

  BOLT PATTERN

 .......................................................................................... 54

    Bolt Pattern – 

Model 4086

 ........................................................................ 55

    Bolt Pattern – 

Model 4087

 ........................................................................ 56

  RIGHT TRIANGLE FUNCTIONS 

(NOT AVAILABLE ON MODEL 4086)

 ..................... 57

    Right Triangle – 

Based on Adjacent and Opposite Legs

 .......................... 57

    Right Triangle – 

Based on Hypotenuse and Angle

 ................................... 58

  CIRCLE CALCULATIONS

 ........................................................................... 59

    Circumference and Area – 

Based on Diameter

 ........................................ 59

    Circumference and Area – 

Based on Radius

(NOT AVAILABLE ON MODEL 4086)

 ........................................................................ 59

  BASIC D:M:S AND TRIGONOMETRY EXAMPLES

 ................................... 59

    Converting Degrees:Minutes:Seconds

 ..................................................... 59

    Time Calculations Using D:M:S

 ................................................................ 60

    Trigonometric Functions 

(NOT AVAILABLE ON MODEL 4086)

 ................................ 60

APPeNDIX A

 – 

DEFAULT SETTINGS

 .......................................................... 62

APPeNDIX b

– PREFERENCE SETTINGS

 ..................................................

63

APPeNDIX C 

– CARE INSTRUCTIONS

 ........................................................ 66

APPeNDIX D – 

ACCURACY/ERRORS, AUTO  

SHUT-OFF, BATTERIES, RESET

 ................................................................. 66

RePAIR AND ReTURN

 .................................................................................. 68

WARRANTY

 ................................................................................................... 69