Calculated Industries Machinist Calc 4086 User Manual - 6 — M

6 — M

achinist

 c

alc™

/ M

achinist

 c

alc™

 P

ro

Dimensional function Keys 

m

Millimeters — 

Identifies entry as millimeters, with 

repeated presses toggling between linear, area and 

volume units. Converts dimensional value to units of 

millimeters, with repeated presses toggling between 

millimeters and meters.

g 5

Centimeters (cm) — 

Identifies entry as 

centimeters, with repeated presses toggling 

between linear, area and volume units. 

g 9

Meters (m) — 

Identifies entry as meters, with repeat

-

ed presses toggling between linear, area and volume 

units.

g 7

Feet

—

Identifies entry as Feet, with repeated press

-

es of 

g 7

 toggling between linear, area and volume 

units. Also used with 

i

 and 

/

 for entering Feet-Inch 

values. Repeated presses of 

g 7

 during conversions 

toggle between fractional Feet-Inch and decimal Feet.

i

Inch —

 Identifies entry as Inches, with repeated 

presses toggling between linear, area and volume 

units. Entry can be whole or decimal numbers. Also 

used with 

/

 for entering fractional Inch values (e.g., 

9 i 1 / 2

). Repeated presses during conversions 

toggle between fractional and decimal Inches.

/

Fraction Bar — 

Used to enter fractions. Fractions 

can be entered as proper (1/2, 1/8, 1/16) or improper 

(3/2, 9/8). If the denominator (bottom) is not entered, 

the calculator’s fractional accuracy setting is 

automatically used. Results are always shown in 

typical dimensional fractional format.

B

1/1000” (mils) —

 Multiplies a dimensionless entry by 

0.001 Inch and displays the result as Inches. Converts 

a linear entry to decimal Inches. For both methods, 

the result is rounded and displayed to three decimal 

places.