Calearo CPA-Cellular User Manual - page 19
http://www.calearotlc.com
CPA - CELLULAR PHONE AMPLIFIER
User’s guide – Guida utente – V1.2
pag. 19 di 23
Calearo TLC - Via Bacchiglione, 49 - 36033 Isola Vicentina (Vi) - Italy Tel +39 0444-901311 - Fax +39 0444-901375 -
www.calearotlc.com
All rights reserved. Calearo TLC can make changes or improvements of the present document in any moment and without notice.
8 Understanding the Amplifier’s LEDs – Comprendere i LED
dell’amplificatore
Figure 10 Amplifier LEDs - LED dell'amplificatore
During the normal operation of GSM and
DCS bands only the green “PWR” light is
on.
In case of Shut-Down of GSM (or DCS)
band, when Output Power Overload or
Oscillation occur for longer than 5
seconds:
1. The red light of GSM (or DCS) turns
on, indicating the Shut-Down mode.
The Shut-Down will last for 5
seconds. Then it will automatically
return to Normal Operation (first auto-
reset).
2. If
Output
Power
Overload
or
Oscillation continues even after the
first auto-reset, the red light (Shut-
Down) will turn on again. The auto-
reset will take place up to 3 times.
3. When
Over-Output-Power
or
Oscillation still exists after the third
auto-reset, the Shut-Down will be for
60 seconds before the next auto-reset
occur.
4. The Shut-Down function will repeat
steps 1 through 3 continuously and
automatically, until the corrective
action steps as follows are taken:
A.
Place the Amplifier Unit or the
inside antenna sufficiently away
from the outside antenna.
Or:
B.
Make sure that the outside
antenna is facing away from the
Amplifier Unit and the inside
antenna.
Durante il normale funzionamento delle
bande GSM e DCS solamente la
segnalazione PWR è accesa, colore
verde.
Lo spegnimento si attiva in caso di Output
Power Overload o oscillazione nella
banda GSM (o DCS), per un periodo
maggiore a 5 secondi:
1. La luce rossa del GSM (or DCS) si
accende, indicando la modalità di
spegnimento. Lo spegnimento dura 5
secondi. In seguito, il dispositivo
ritorna al funzionamento normale
(primo auto-reset).
2. Se
l’Output
Power
Overload
o
l’oscillazione persiste dopo il primo
auto-reset,
la
luce
rossa
(spegnimento)
si
accende
nuovamente. L’ Auto-reset si ripete per
tre volte.
3. Quando l’Output Power Overload o
l’oscillazione persiste dopo il terzo
auto-reset, il dispositivo si spegne per
60 secondi prima di effettuare il
successivo auto-reset.
4. La funzione di spegnimento ripeterà i
passi da 1 a 3 in continuazione fino a
che
non
verranno
realizzate
le
seguenti azioni correttive:
A. Piazzare l'amplificatore o l' antenna
interna lontana da quella esterna.
B.
Assicurarsi che l’antenna esterna
non sia diretta verso l’Amplificatore
o l’antenna interna.
BLOCCO DEL SISTEMA
SOLUZIONI
oppure sostituire l’antenna esterna
con una Compact orientandola
di schiena alla Compact interna.