Calearo CPA-Cellular User Manual - page 20
http://www.calearotlc.com
CPA - CELLULAR PHONE AMPLIFIER
User’s guide – Guida utente – V1.2
pag. 20 di 23
Calearo TLC - Via Bacchiglione, 49 - 36033 Isola Vicentina (Vi) - Italy Tel +39 0444-901311 - Fax +39 0444-901375 -
www.calearotlc.com
All rights reserved. Calearo TLC can make changes or improvements of the present document in any moment and without notice.
9 Array antenna installation – Installazione dell’antenna Array
In order to have the best performances from
the device, you should observe the following
guidelines when you install the Array antenna.
Per avere le migliori prestazioni dal dispositivo
occorre osservare le seguenti linee guida per
l’installazione dell’antenna Array.
Figure 11 Array antenna installation - Installazione dell'antenna array.
Important notes:
Always install the antenna in vertical
position as shown by the mark "ALTO"
(“UP”) printed on it.
The height from the ground must be at
least 1,5 m, in order to reduce reflections.
Install the antenna as far away as
possible from metal parts or structures.
Pole installation (A):
The installation on a pole (optional)
enhances
the
omnidirectional
performances of the antenna; the fixing
can be made by the bracket pole kit
included in the package, the pole
diameter can vary from Ø30 mm to Ø42
mm.
Wall installation (B - C):
The wall installation needs screw anchors
(not included in the package) with not
countersunk screws. In case of use of the
countersunk screws, add washers to
protect the antenna.
The cable can be inserted into a hole in
the wall (B) or bended into the 90° bracket
slot (C), in order to protect it from buckling
or breaking.
Note importanti:
Installare sempre l’antenna in posizione
verticale, come mostrato dalla scritta
sovraimpressa "ALTO".
L’altezza dal pavimento deve essere di
almeno 1,5 m, per ridurre l’effetto delle
riflessioni.
Installare l’antenna quanto più lontano
possibile da parti e strutture metalliche.
Installazione a palo (A):
L’installazione a palo (opzionale) migliora
le
prestazioni
omnidirezionali
dell’antenna. Il fissaggio può essere fatto
su una staffa a palo di diametro variabile
da Ø30 mm a Ø42 mm.
Installazione a parete (B - C):
L’installazione a muro richiede viti di
fissaggio con tasselli ad espansione (non
forniti nella confezione), possibilmente
con viti a testa cilindrica non svasate. Nel
caso
si
utilizzino
viti
svasate
salvaguardare con delle rondelle l’integrità
dell’antenna.
Il cavo può essere infilato attraverso un
eventuale foro sul muro (B) o ripiegato
nell’asola della staffa a 90° dell’antenna
(C), in modo tale da preservarlo da
schiacciamento o rottura.