Caliber RCD 120 Manual - Rcd 120 • Manual
RCD 120 • MANUAL
16
SPECIFICATION
General
Power Supply Requirements:
DC 14
.
4V“ ”, Negative Ground
Maximum Output Power:
Chassis Dimensions:
178 x 163x 50mm (W x D x H)
Tone Controls
Bass (at 100Hz):
+10dB / -10dB
Treble (at 10K):
+10dB / -10dB
Current Drain:
10A
CD Player
Signal to Noise Ratio:
More than 60dB
Channel Separation:
More than 60dB
Frequency Response:
20Hz - 20KHz
FM Radio
Frequency Coverage (MHz):
87
.
5 - 108MHz
IF :
10.7MHz
Sensitivity (S/N-30dB):
12dBu
Stereo Separation:
>30dB
25W x 4(CH)
Load
Impedance
:
4
ohms
Remarks
:
Specifications
subject
to
change
without
notice
INPUT THE SD CARD
The
SD
oblique
angle
keeps
rightward
exposure
,
put
into
the
SD
slot
and
press
it
again
to
eject
.
DIN REAR-MOUNT (Method B)
Installation using the screw holes on
the sides of the unit
Fastening the unit to the factory
radio mounting bracket:
1. Select a position where the screw
holes of the bracket and the
screw holes of the main unit
become aligned (are fitted), and
tighten the screws at 2 places on
each side. Use either truss screws
(5 x 5mm) or flush surface screws
(4 x 5mm)
2. Screw
3. Dashboard or Console
1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw
2.Insert fingers into the groove in the
front of frame and pul l out to remove
the frame. (When reatt achi ng the
frame, point the side with a groove
dow nwards and attach it.)
3.Leve r
Insert the levers supp lied with the
uni t into the grooves at both sides of
the uni t and show n in figure unti l they
click. Pulling the levers makes possible
to remove the unit fro m the dashboard.
INSTALLATION
6. Strap
Be sure to use the strap to
secure the back of the unit in
place. The strap can be bent by
hand to the desired angle.
7. Plain Washer
2
3
2
2
1
3
(
Fig
.
3
)
Removing
the
unit
1
2
3
4
5
6
7
(
Fig
.
2
)
03