Calibre Fitness CIT-9013 Owner's Manual - page 12
Manual is about: cable crossover
of
21
─ 12 ─
Assembly
Step 4
1. Slide weight bumper (#34) and guide rod (#8) into holes of middle base (#3).
2. Slide Weight Plate Unit (#31) (including ten Weight plate 15LBS, three Weight
plate 10LBS and two Weight plate 5LBS) onto guide rod (#8), then slide top
plate (#30) onto top of weight stack. Attach guide rod (#8) with main base (#2)
using:
two rubber caps (#52) two M10*25 SHCS (#44)
3. Attach one Swivel Pulley Block (#15) and one Jam Nut (#18) with the top
plate (#30).
4. Repeat STEP 4 on other side.