Calibre UK VideoExcel Operating Instructions Manual - page 21
© Calibre UK Limited Issue 4.00 22
nd
January 2014, W: www.calibreuk.com
Page 21
T:+44 1274 394125 F: +44 1274 730960 E:
techsupport@calibreuk.com
,
Movie Mode
Movie Mode is set to Auto by default. VXL-150HD detects film content converted to
video and applies the inverse telecine process. In the unlikely event that this automatic
detection fails the unit can be forced to treat the incoming signal as either video or
film. When set to video motion adaptive de-interlacing is applied. This setting will
eliminate all feathering that may appear in Auto setting, but image detail is reduced for
film originated content. The Film setting will apply an inverse telecine process no
matter of the content. This will give great detail for film originated content video. If the
content is video this setting shows unacceptable feathering. When such artefacts are
observed the Video or Auto setting is more appropriate.
4.6.9.
Audio Channel Swap
Audio input channels are the 4x AES coaxial connectors and audio embedded in HDMI and SDI video
streams for VXL-100, and VXL-150. Audio input channels are analogue stereo L/R, SPDIF coaxial
digital audio and audio embedded in HDMI and SDI video streams for VXL-75HD. By default the AES
output channels 1, 2, 3 and 4 get the input audio in sequential order, e.g. 3GSDI audio group 1 channel
1 is routed to AES output 1, group 1 channel 2 is routed to AES output 2 and so forth. The Audio
Channel Swap menu item allows the order of audio channels to be changed or for multiple AES outputs
to be assigned to the same input channel.
The audio is passed through the system and re-embedded into the HDMI and SDI output signals with an
appropriate delay to synchronize with the video stream. Also, audio output is present on the respective
4x AES coaxial connectors. Any PCM audio of 32kHz, 44.1kHz, and 96kHz is resampled to 48kHz.
Higher sample rate PCM audio such as 192kHz is muted. Any compressed audio is passed through if
the original audio is identified as 48kHz sampled audio or muted. Incoming Dolby E audio is muted.
Output Channel
Output Format
HDMI
PCM up to 8ch, up to 24Bit, 48kHz sampling rate
Dolby Digital (AC3) up to 5.1 channels, up to 640kBit/sec bit stream rate
MPEG2 up to 8ch, up to 112kBit/sec bit stream rate
DTS up to 6.1 channels, up to 1536kBit/sec bit stream rate
SDI
PCM up to 8ch, up to 24Bit, 48kHz sampling rate
4x AES
PCM up to 8ch, up to 24Bit, 48kHz sampling rate
Dolby Digital (AC3) up to 5.1 channels
DTS up to 6.1 channels