California Patio Gas BBQ Grill Owner's Manual - For Outdoor Gas Grill

Summary of Gas BBQ Grill

  • Page 1

    O w n e r s m a n u a l gas bbq grill gas bbq grill www.Californiapatio.Jp.

  • Page 2: For Outdoor Gas Grill

    Keep these instructions for further use assembly and users' instructions for outdoor gas grill using liquid petroleum gas your new california patio gas grill is made from the highest quality materials, and produced under strict manufacturing controls. Please read the instructions for assembly before...

  • Page 3

    Contents page 1. Technical data 2. Guarantee 3. Instructions for assembly 4. Setting up 5. Connecting gas 6. Instructions for first users 7. Instructions for use 8. Cooking tips 9. Care & maintenance 10. Troubleshooting 3 3 4 - 10 11 11 11 12 12 12 10 1). Technical data type of gas propane gas conta...

  • Page 4

    Page 4 1 2 3 4 5 6 15 16 17 18 20 21 22 23 19 11 12 13 14.

  • Page 5

    Page 5 1 wheel axle 500 001 2 wheel 500 002 3 side shelf slat ( wooden ) 526 001 4 gas tube 500 003 5 grease can holder 6 500 004 -- 8 9 lid handle 10 washer 526 005 11 lid 526 006 12 grill grid chrome plated 526 007 13 lava grid 526 008 14 burner oval 526 009 15 lid bolt 526 010 16 bottom casting 5...

  • Page 6

    7 10 9 8 2 3 12 1 6 11 5 4 page 6 diagram 1 screw the legs (7) on the right and left, front and back each with two screws respectively (10), with washers (9) and nuts (8) to the ground plate (2). The closed side of the ground plate is placed upwards. Straighten the legs downwards and tighten the scr...

  • Page 7

    2 1 4 3 7 5 6 8 9 5 1 2 3 4 6 page 7 diagram 2 position the gas valve (2) with the pre-assembled hose, as shown, from behind into the two big holes (4) of the front panel (7), so that the cam (3) will fit into the lower small hole on the front panel. Screw the thick short crossbar screw (5) into the...

  • Page 8

    Page 8 2 1 5 4 6 3 diagram 4 take the bottom casting (2) and set it on to the holders (1) and the front panel (5). Match the four holes in the bottom of the bottom casting to the four holes in the bottom casting holders and the front panel. Stick a screw (4) through the holes and screw them together...

  • Page 9

    3 1 2 8 7 6 4 5 9 diagram 7 take the complete burner (4) with the venturi pipes (2) and the ignitor collector box (3) and stick it from above with the venturi pipes down through the big opening (1) in the bottom casting. Take care that the venturi pipes (9) slide over the nozzles (8) of the valve wh...

  • Page 10: Trouble-Shooting

    Page 10 2 3 1 diagram 9 place the lava grid (2) on to the lower holders of the bottom casting (3). Spread the lava rocks evenly on the lava grid. To obtain an optimum result in barbecuing the grate should be covered about 70-80%. Place the cooking grid (1) on the upper holders of the bottom casting....

  • Page 11

    Dear user, when you have assembled your barbecue, please pull all screws tight after 2 3 days, especially the screws holding the frame (but do not overtighten them). Only thus can the stability of your barbecue be assured. The materials used tend to loosen again after the first tightening and connec...

  • Page 12

    7.) instructions for use 1.Leak control check. Before use, ensure the security of the gas supply, as stated in section 5. 2.To light. Raise the lid. Do not stoop over the grilling space. Press in and turn both control knobs to “small flame” setting. Then press the red ignitor push button several tim...