Callaway Golf uPro Quick Start Manual

Quick Start Guide

1) 

Remove the battery cover on the uPro. While pressing  

the upper center portion of

the battery cover firmly, slide 

the battery cover downward to remove.

2) 

Insert the Li-Ion rechargeable battery into the battery 

compartment. Angle the battery such that the bottom  

edge with the three contacts makes contact with the  

connector on the uPro first and then push the top side  

of the battery into place. The text on the battery should  

be facing up. 

Handle your Li-Ion battery with care.  

See battery warning sheet for additional information.

3) 

Replace the battery cover.

4) 

Insert the mini-USB connector of the included USB cable 

into the USB connector on the bottom of the uPro.

5) 

Connect the other end of the USB cable to the included 

wall adapter.

6) 

Plug the wall charger into an AC wall outlet. The uPro’s 

red LED will be lit while charging. If the red LED is not lit, 

check your connections, and if the problem persists, please 

reference the full User Manual at 

www.callawaygolf.com/

uprogps

. The red LED will begin to flash when charging  

is completed. Charging the battery completely takes  

approximately 3 hours. 

Charging your Callaway uPro

®

Powering On 

Once you have charged your uPro, disconnect it from  

the USB cable and power it on by pressing 

and holding

the Power/Menu button for at least three seconds (until  

the startup screen appears). The startup screen will show 

four open dots which will fill-in as the startup progresses, 

and then the Main Menu will be displayed.

Registering your Callaway uPro®

In order to use your uPro on the course, you will need  

to register your uPro and create a user account online at  

our website.

1) Power on the Callaway uPro – 

Press and hold the power 

button for 3 seconds to power on the uPro. Once the startup 

screen appears, the uPro is powered on.

2) Connect to a computer – 

Once the Main Menu is dis-

played on the uPro, connect the USB cable to the uPro. Insert 

the mini-USB connector (smaller connector on the cable) 

Buttons

Right LCD 

Select  

Directional 

Arrows

Left LCD 

Select 

USB

Select/Enter

Headphone

Voice  

Recognition

LED Light

Power/Menu

ProMode 

Button

Microphone

Battery Cover

Press Down 

& Slide Open

USB Port

Headphone Jack