CallerID Whozz Calling? 4 POS Caller ID Technical manual - page 9
8
Specifications
Supply Voltage:
9 VDC, center negative
Supply Current:
Less than 250 mA
Loop Current Draw:
Less than 1 mA
Loop Voltage:
30 to 105 VDC
Ringing Voltage:
60 to 130 VAC
Insertion Loss:
Less than 0.3 dB
Voltage Drop:
2.7 VDC at 20 mA loop current
Ringer Equivalence:
(REN) 0.1 B
Dimensions:
4.3" x 3.25" x 1.5"
Manufacture’s Information
CallerID.com
3107-D Medlock Bridge Road
Norcross, GA 30071
Sales
(800)
240-4637
Customer Service
(770) 263-7111
FAX
(770)
263-0049
Web Site
www.callerid.com
Warranty Information
CallerID.com will repair this product with new or rebuilt parts, free of charge, when returned shipping prepaid to the
CallerID.com repair facility in Norcross, GA within 12 months from the date of original purchase. This warranty is
extended only to the original purchaser. A purchase receipt or other acceptable proof of purchase date will be required
before warranty service is rendered.
This warranty covers failures due only to defects in materials or workmanship occurring during normal use. It does not
cover damage which occurs in shipment; failures which are caused by products not manufactured by CallerID.com;
failures which result from accident, misuse, abuse, neglect, mishandling, misapplication, alteration, modification or
unintended use of product; service by anyone other than an authorized CallerID.com repair facility; or damage attributed
to an act of God. Lightning is considered an act of God. CallerID.com makes no other warranty, either expressed or
implied, with respect to this product. If a problem develops concerning this product, contact CallerID.com directly for a
Return Material Authorization (RMA).
FCC Information
This unit is designed to conform to federal regulations and complies with Part 68 of the FCC rules. On the back of this
equipment is a label that contains the FCC registration number and ringer equivalence number (REN) for this
equipment. Upon request, you may have to provide the FCC registration number and the REN to your telephone
company.
The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line.
In most areas, the sum of the RENs on any one line should not exceed 5. If too many devices are attached, your phones
may not ring properly and other devices on the line may not detect the ring signal.
In the most unlikely event that your unit causes significant problems on the telephone line, the telephone company can
disconnect your service. The telephone company will attempt to notify you in advance and will advise you of your right
to file a complaint with the FCC. The telephone company may make changes in its technical operation and procedures
that may affect the operation of this device. The telephone company is required to give adequate notice of such changes.
This product should not be connected to coin operated or party line systems.