Calomax Eclipse Series Installation, Operation And Servicing Instructions - Location
Page 4
LOCATION
INSTALLATION AND MAINTENANCE
All metallic components of the machine, in direct contact with
drinking water are manufactured from high quality 304 grade
stainless steel, or non ferrous materials, providing maximum
resistance to corrosion.
CONSTRUCTION
To comply with recommendations from the Health and
Safety Executive it is important that due consideration
be given to safe operation of the controls of the boiler.
The boiler should therefore be mounted in such a
manner that the operator can stand directly facing
the machine with the controls at a recommended
height from the floor to the draw-off tap handle of
1200mm +/- 100mm. Consideration should also be
The boiler must be installed in a location where access is
restricted to operators that are suitably trained, or where untrained
operators of the machine can be supervised by trained personnel.
Calomax products have been tested and found
to comply with the requirements of the Water
Supply (Water Fittings) Regulations 1999
for England and Wales Water Bylaws 2000,
Scotland and the Water Regulations Ireland.
given to the servicing requirements of the machine. The maximum
and minimum ambient operating conditions must be between
5 °C and 35 °C. The appliance is not suitable for installation where
a water jet could be used. Install the boiler on a surface or wall
suitable for the working weight of the boiler. Allow clearance for
ventilation and for the easy removal of the outer casing lid and front
panel. Calomax ltd recommend a minimum clearance of 50mm on
all sides of the boiler. A suitably qualified engineer must install this
unit. Plumbing and electrical installation work may be involved.
p
PP