Cama HANDI-LIFT 7 Installation Manual - page 6
of
14
Handi-lift 7
2010
Page 5
Version 1.0
fig. 2
Mark measurement B
Mark measurement C from the first and last
raise parallel with the staircase.
Note! Measurement C is the upper edge of the
inner profile.
Make a line through mark A-A and D.
And make a line through mark C-C.
fig. 1
fig. 2
Place the upper rail on the wall
or columns and fasten it in
each end, on a wall installation
drill ø12-14mm holes in the
wall for glue bolts. Minimum
90mm into the wall.
On an installation on columns
drill ø8,5mm holes and make a
M10 threads.
Be careful not to hit the rail.
Do the same with the support rail for the lower rail. Using a ø10mm drill bit for ø10 raw
plugs.