Camarcio AC 500 TR Instruction Manual - page 3
PERFORMANCE PARAMETERS
MODEL
RATING POWER
RATING
COOLING POWER
MAXIMUM
WATER
INJECTION RATE
SPECIFICATION
AC 500 TR
220V,50Hz
75W
7L
COOLING ONLY
FUNCTIONS
● Principle of Cooling: Water is took from the water tank by pump to the top, then the water
drops into paper evaporator . When the water in paper evaporator evaporates to water vapor,
the air is cooled. People will feel cool wind when the cool air is delivered by fan.
● Electronics control: safe and durable, have an attractive appearance.
● Adjustable speed and fan type: have three speeds and fan types, and it can send wind from
side to side neatly.
● Cooling: Through air evaporating, cut down the air temperature and raise relative humidity.
● Deliver wind at wide angle: swing the blades automatically, deliver wind at wide angle. Also
swing the blades transversely by your hands, choose the wind direction up and down..
● Remote control: 6 meters far away, receive at 60 degree wide angle.
ASSEMBLING AND WATERING
1. Assembling castors: put the appliance on a flat surface, take out the wrench from foam box,
then assemble the castors.
2. Watering: pull 1/3 water tank, then add clean water
3 Attention:
a. Pay attention to the level of water tank when add water.
b. The level of water tank should not over “MAX” scale at any time, when humidifying, the
total level of water tank should not below “MIN” scale.
c. Put ice or frozen ice box to the water tank if you want to strengthen the efficiency of
cooling. But the total level of water tank should not over “MAX” scale.
OPERATION A—USE AS AIR COOLER
● Mode of cooler: Please find a lever switch on side panel, pull this switch to “Cooler”
● ON/OFF at the back side: Please find this key and turn on the power at the BACK of
appliance, the air cooler and heater will be ready, at the same time the buzzer reminds “Bi”.
When the appliance need stop to work, please turn off.
● ON/OFF on control panel : Press the key, turn on the appliance, second press, shut it down .
Speed: press this key, start the appliance, the corresponding function changes as follows when
you press the key serially: LOWMEDIUMHIGHLOW. NOTE: heater is only with
light direct (when the light is shine it’s HIGH, if not it’s LOW)
● Wind type: press this key, you can choose the normal wind, natural wind and sleeping wind