Camarcio AC 500 TR Instruction Manual - page 4
circularly. Under the situation of normal wind it has no corresponding indicator light, but
others have. NOTE: heater has no this function.
● Swing : press this key, the wind direction can swing flatly, and the swing indicator light is on.
It cancels this function when you press again. NOTE: You also can swing the blades
transversely by your hands, choose the wind direction up and down.
● Timer key: press this key, the timer from 0.5 to 7.5 hours options with step 0.5 hours. It will
shutdown if the timer finished.
● Cooling: press the key to start cooling system.
It cancels this function when you press again.
IMPORTANT: Please be sure there is enough water in the water tank before press this key.
● Heating: This key is not available for cooler
THE USE OF REMOTE CONTROL
Fit on batteries, it can works. There have 7 keys on the remote control, and have the same function
as control panel. Should aim at the remote control reception window when you use, and the
effective distance is 6 meters. When the remote control is not in use, please put away it for using
next time.
Attention:
a. Do not mix old battery with the new one in use.
b. Please take out the batteries for long time nonuse.
c. The remote control has no mode key, so press the key by your hands.
THE USE OF ICE BOX
The ice crystal has a particular feature of keeping cool, it can absorb heat from water and let the
water temperature in the water tank below environmental temperature, so the air will be much
cooler.
Using methods:
a. add water to the ice box(not full) and put it into the refrigerating chamber of refrigerator to
make sure that it icing absolutely.
b. Open the door, put the frozen ice box into the water tank.
c. There have two air boxes ,can use circularly.
CAUTION
1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, it should be repaired by the repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replaced by a special cord or assembly available
from the manufacturer or its service agents.