Cambridge SoundWorks SoundWorks Digital Installation And Operating Instructions Manual

Other manuals for SoundWorks Digital: Instructions Manual
Manual is about: Multimedia Speaker System

Summary of SoundWorks Digital

  • Page 1

    Cover.Fm page 1 tuesday, october 17, 2000 2:06 pm.

  • Page 2

    1 fcc part 15: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,...

  • Page 3

    2 read instructions - all safety and operating instructions should be read before the soundworks digital amplified subwoofer/satellite system is operated. Retain instructions - the safety and operating instructions should be retained for future reference. Heed warnings - all warnings on the subwoofe...

  • Page 4: Contents

    3 contents installation sequence........................................................................... 5 satellite connection ............................................................................. 6 audio signal connections ...................................................................

  • Page 5: Introduction

    4 introduction hank you for buying soundworks digital by cambridge soundworks. Soundworks digital, based on the award-winning cambridge soundworks fourpointsurround fps2000 digital, is the first 2.1 digital speaker featuring a spdif digital input for crystal clear, distortion-free audio. Its second ...

  • Page 6: Inspecting For Damage

    5 examine each speaker unit carefully for shipping damage. If there is any, do not install or use the system. For advice, call the store where you made your purchase. All of the items shown in the illustration below should be included with your system. Inspecting for damage please note that the type...

  • Page 7: Satellite Connection

    6 1. From both ends of each speaker wire, pull off and discard the precut strips of insulation, revealing the bare wires. 2. Twist the individual strands of bare wire tightly together so that there are no free strands that could short across the speaker or amplifier terminals. 3. To connect the spea...

  • Page 8: Audio Signal Connections

    7 spdif digital in if you are connecting to sound blaster live! Or a card with the same type of spdif output, connect the mono miniplug end of the rca-to-mono cable to the spdif output jack. Connect the rca jack of the same cable to one rca plug of the rca-to-rca cable. Connect the other rca plug to...

  • Page 9

    8 analog inputs connect one of the stereo miniplugs of the supplied stereo audio cable to the audio output jack of your computer. Connect the other miniplug to either of the two audio inputs on the subwoofer. You may simultaneously have another audio signal connected to the other audio input on the ...

  • Page 10: The Volume Control

    9 remove remaining paper strip. The volume control contains the power on/off switch and an led power indicator, as well as the master volume control. Connect the volume control to the subwoofer (see diagram b on page 7). This control can be mounted on the side of your computer monitor or other surfa...

  • Page 11: Attaching The Stands

    10 make sure that the speaker wire is attached to the satellites before you attach the stands to the satellites. Attaching the stands speaker placement the ear cannot localize low bass, which is why the subwoofer can go on the floor, out of sight. The bass port (the hole on the side of the control p...

  • Page 12: Mounting The Satellites

    11 mounting the satellites to the monitor to mount the satellites to the side of a monitor, use two of the self-adhesive “hook and loop” fasteners per satellite (see diagram g). To the wall to wall-mount the satellites on structurally strong surfaces (a wall stud or wood paneling), screw the m5x25mm...

  • Page 13: Playback Levels

    12 playback levels this speaker system is intended for individual or small group listening and will achieve surprisingly high output levels. However, playing the system continuously at overly loud, distorted levels on heavy-bass program material may cause its internal fuse to blow. The fuse can be r...

  • Page 14: 1-Year Limited Warranty

    13 o the original purchaser, cambridge soundworks, inc. Will warrant the speaker system to be free of defects in material and workmanship for a period of one (1) year from date of purchase. With respect to defects, cambridge soundworks will, at its option, replace the product or repair the defect in...

  • Page 15: Technical Support

    14 if you need technical assistance, call 1-405-742-6622. Operating hours (central times): mon-sat: 8.00 a.M.-10.00 p.M. And sun: noon-8.00 p.M. You can also send a fax at 1-405-742-6633 or write us at: technical support creative labs, inc. 1523 cimarron plaza stillwater, ok 74075 to reach creative ...

  • Page 16

    311 needham street, newton ma usa 02464 1-800-937-4434 fax: 617-527-3194 www.Cambridgesoundworks.Com or e-mail us at info@cambridgesoundworks.Com 0420000698 rev. B cover.Fm page 2 tuesday, october 17, 2000 2:06 pm.