CAME AX3024 Installation Manual - page 3
(57.2mm) diameter sphere from passing through the openings anywhere in the
gate, and in that portion of the adjacent fence that the gate covers in the open
position,
3.
All exposed pinch points are eliminated or guarded, and
4.
Guarding is supplied for exposed rollers.
B.
The operator is intended for installation only on gates for vehicles. Pedestrians must be
supplied with a separate access opening. The pedestrian access opening shall be
designed to promote pedestrian usage. Locate the gate such that persons will not come in
contact with the vehicular gate during the entire path of travel of the vehicular gate.
C.
The gate must be installed in a location so that enough clearance is supplied between the
gate and adjacent structures when opening and closing to reduce the risk of entrapment.
Swinging gates shall not open into public access areas.
D.
The gate must be properly installed and work freely in both directions prior to the
installation of the gate operator. Do not over-tighten the operator clutch or pressure relief
valve to compensate for a damaged gate.
E.
For gate operators utilizing Type D protection:
1.
The gate operator controls must be placed so that the user has full view of the gate
area when the gate is not moving.
2.
The placard provided marked in letters at least ¼-in(6.4mm) high with the word
“Warning” and the following statement or the equivalent: “Moving Gate Can
Cause Serious Injury or Death” shall be placed adjacent to the controls,
3.
An automatic closing device (such as a timer, loop sensor, or similar device) shall
not be employed, and
4.
No other activation device shall be connected.
F.
Controls intended for user activation must be located at least six feet (6’) away from any
moving part of the gate and where the user is prevented from reaching over, under,
around or through the gate to operate the controls. Outdoor or easily accessible controls
shall have a security feature to prevent unauthorized use.
ENGLISH ENGLISH