CAME AX3024 Installation Manual - page 4
G.
The Stop and/or Reset button must be located in the line-of-sight of the gate. Activation
of the reset shall not cause the operator to start.
H.
A minimum of two (2) WARNING SIGNS shall be installed, one on each side of the
gate where easily visible.
I.
All gate operators systems should include safety devices such as reversing edges or
photocells in order to provide added protection. These safety devices should be installed
in accordance to the design and application of the system being installed.
J.
A qualified professional installer should install a gate operator system, its safety
accessories and should observe these minimum procedures:
a.
Power should be disconnected before installing or servicing a gate operator.
b.
All electrical wiring should comply with all local building and electrical codes.
c.
All entrapment zones and pinching points should be covered.
d.
All safety devices should be tested to assure their proper functionality.
e.
The operation of the gate system: operator, controls and safety devices should be
reviewed with the end user or owner, who should be informed of the need for
periodic maintenance of the safety and control equipment.
f.
All installation operating and safety manuals should be left with the owner.
CAME AUTOMATIC GATES UL 325 CLASSES
CLASS
DUTY CYCLE
AXO-AX5024
I
Residential Vehicular Gate Operator
Typical use: Home, 1-4 apartment condominium. Limited Public access.
Continuous
X
II
Commercial/ General Access Vehicular Gate Operator
Continuous
X
III
Industrial / Limited Access Vehicular Gate Operator
Typical use: Industrial location, Factory, Loading Dock. No Public
Access.
Continuous
X
IV
Restricted Access Vehicular Gate Operator
Typical use: Security area with restricted access. No public access.
Continuous
X
ENGLISHENGLISH
Typical use: Condominiums, hotels, parking lots. No general public access.