CAME BK 1200 Installation Manual - page 11
+
-
43
43
0
-/4
#
# #8
#8
,
.
5
6
7
% %8
%8
Eyelet cable terminal with screw
and washer for ground connection
Connections for power source and accessories
Electric power
120V – 230W
(a.c.) – 50/60 Hz
24V (d.c.) output to
power accessories
(20W max.)
(N.C.) contact for “re-opening during closing”
– Input for safety devices such as photocells, sensiti-
ve safety edges and other devices compliant with EN
12978 standards. When the gate leaf is closing, ope-
ning the contact triggers the inversion of the direction
of movement until the gate leaf is fully open.
(N.C.) contact for “partial stop” – Input for safety
devices such as photocells, sensitive safety edges and
other devices compliant with EN 12978 standards. If
in motion, the gate leaf stops, and automatic closing is
consequently triggered. DIP 8 OFF – DIP 9 ON.
(N.C.) contact for “re-closing during opening phase”
– Input for safety devices such as photocells, sensiti-
ve safety edges and other devices compliant with EN
12978 standards. When gate is opening, if the contact
is opened it triggers an inversion of the direction until
gate is fully closed. DIP 8 OFF – DIP 9 OFF.
Connections to safety devices (DIR photocell)
Set power supply to
24V a.c./d.c.
48
#
.#
6
6
6
6
48 # .#
48
48
48 # .#
RX
TX
RX
TX
Fan (contact output: 230V – 25W) –
Connection for the fan which cools the
gear motor. Each time the gate leaf is
opened, the fan stays on for a fixed time
of 5 minutes and 30 seconds.
DIP 16 ON – DIP 17 OFF
(only for the BK800 version)
11
A
ll t
h
e d
at
a a
n
d i
n
fo
rm
at
io
n c
o
n
ta
in
ed h
er
ei
n
i
s c
o
n
si
d
er
ed
s
u
b
je
ct to c
h
an
g
e a
t a
n
y t
im
e a
n
d a
t o
u
r d
is
cr
et
io
n
ENGLISH