CAME FA40230 Installation manual - page 35
p.
3
5
3
5
- M
a
n
u
a
l c
o
d
e:
1
1
9
D
W
0
2
11
9
D
W
0
2
v
e
r.
2
.0
2.
0 0
6
/2
0
12
© C
A
M
E
C
a
n
ce
lli A
u
to
m
a
ti
ci
S
.p.
A
. - T
h
e d
a
ta a
n
d i
n
fo
rm
ati
o
n i
n
t
h
is
m
a
n
u
a
l m
ay b
e c
h
a
n
g
e
d at a
n
y time a
n
d wit
h
o
u
t o
b
lig
a
ti
o
n
o
n
t
h
e p
a
rt
of C
a
me C
a
n
ce
lli A
u
to
m
ati
ci
S
.p.
A
. to n
o
tif
y s
a
id
c
h
a
n
g
e
s.
ENGLISH
This product is only intended to be used for the purpose it was designed. Any other use is therefore
improper and dangerous. The manufacturer is not liable for any damage caused by improper, wrongful
or unreasonable use.
Stay away from working mechanical parts. Stay out of the working range of the moving operator.
Do not oppose the movement of the operator as this may result in danger.
Do not allow children to play to loiter within the working range of the operator. Keep transmitters and any other command devices away from children,
to prevent the operator from being activated by mistake.
Immediately stop using the operator if any anomaly is manifested.
Danger high voltage
Transit forbidden during opera-
tion
Important general safety instructions
Safety instructions
Error messages
Er1: calibration of motor M1 interrupted; check proper connection and operation of motor M1.
Er2: calibration of motor M2 interrupted; check proper connection and operation of motor M2.
Er3: encoder out-of-order; call for assistance.
Er4: services test error: check proper connections and functioning state of the safety devices.
Er5: insuffi
cient working time; check the set time, it could be insuffi
cient to complete a full cycle.
Er6: maximum number of detected obstacles
C0: contact 1-2 (stop) unused and not deactivated
C1/2/3/4/7/8: unused and not deactivated CX and/or CY contacts
RED fl ashing LED: command board still not calibrated to the travel.
Periodic servicing performed by end-user includes: cleaning the photocells' glass, checking the proper working state of the safety devi-
ces and making sure the operator is free of any impediments.
We also recommend to periodically check the lubrication the tightness of the bolts and screws on the operator.
To check that the safety devices are working properly, wave an object in front of the photocells during closing; if the operator inverts its direction of
travel or blocks movement, then the photocells are working properly. This is the only maintenance job that should be done with the power source on.
Before doing any maintenance or repair job, cut off the main power, to prevent any dangerous situations.
To wipe clean the photocell glass, use a slightly damp cloth, and do not use any solvents or other chemical products that may ruin the device.
Check that there is not vegetation within range of the photocells, and that no objects interfere with the operation of the automated device.
Maintenance
Periodic maintenance
Danger of hand crushing