CAME GARD 8 SERIES Installation manual - page 14
Pa
g.
1
4
14
- M
an
u
al
c
od
e:
11
9
G
U
4
4
11
9
G
U
4
4
ve
r.
0
.4
0.
4
0
1/
2
0
12 © C
A
M
E c
an
ce
lli auto
m
ati
ci
s.p.a. - T
h
e d
ata a
n
d i
nf
or
m
ati
on
r
ep
orte
d i
n th
is
in
stall
ati
on m
an
u
al a
re s
u
sc
ep
tib
le to
c
h
an
g
e at a
ny tim
e a
n
d with
ou
t o
b
lig
ati
on
o
n C
A
M
E c
an
ce
lli auto
m
ati
ci
s.p.a. to n
otify u
se
rs.
ENGLISH
WARNING! The release
procedure may constitute a
hazard for the user when,
for whatever reason – the
bar is fixed improperly to
the housing during assem-
bly, or the bar is cracked or
broken in an accident, and
so on – the tension springs
no longer provide balance!
These can thus cause a
brusque rotation of the
bar attachment and/or of
the bar itself.
5.9 Manual release of the barrier
- Insert the key in the lock and turn it clock wise. Manually lift the bar and relock it by turning the key
counterclockwise.
6 Description control panel
This product is engineered and manufactured by CAME cancelli
automatici s.p.a. and complies with current safety regulations.
The control panel works on 230V a.c. of power, 50/60Hz
frequency.
Both command and control devices and accessories are 24V
powered.
Warning! Accessories must not exceed 40 W overall.
In case the endpoint assembly does not intervene, the card
nevertheless guarantees 20 seconds of operation. The card
autonomously handles the Encoder (obstacle sensitive) safety
function, which:
- when opening: the bar inverts the direction of travel until com-
pletely closed;
- when closing: the bar inverts the direction of travel until com-
pletely open.
Caution! after three consecutive direction reversals, the bar will
remain up and automatic closure will be discontinued. To close the
gate, use the radio remote control or the push-button.
All connections are protected by quick fuses, see table.
The card provides and controls the following functions:
- automatic closing after an open-command;
- immediate closure;
- pre-fl ashing by the motion indicator;
- obstacle detection when bar is still in any position.
The following command modes are possible:
- open/close;
- open/close and maintained action;
- Opening;
- Total stop.
Apposite trimmer regulate:
- the automatic closing run time;
Optional
accessories:
- fl ashing crown and luminous band.
- bar open light marks the position of opening of the bar; it turns
off after the closing operation;
- the RSE card, in order to activate the compass function or
coupled through Dipswitches, see the relative technical literature.
Warning! Before acting on the machinery, cut off the main power
supply and disconnect any emergency batteries.
TECHNICAL FEATURES
Power supply 230 V - 50/60 Hz
max. rated power 400 W
Power draw when idling 25 W
Max power of 24V accessories 40 W
Insulation rating II
Material ABS
FUSES
protection: fuse type:
Electroblock 1.6 A-F
Electronic board
(power supply line)
5 A-F
Accessories 2 A-F
Control devices 630 mA-F