CAME ZL180 SERIES Installation Manual - page 9
CH1 = A5024N
b)
d)
c)
a)
b)
d)
c)
a)
b)
d)
c)
a)
Pa
g.
99
-
Ma
n
u
al
c
od
e:
3
1
9
U
17
31
9
U
17
ve
r.
1
.2
1.
2
04/2
0
10
9 © C
A
M
E c
an
ce
lli
auto
m
ati
ci
s.p.a. -
Th
e d
ata a
n
d i
nf
or
m
ati
on r
ep
orte
d i
n th
is i
n
sta
lla
tio
n m
an
u
al a
re s
u
sc
ep
tib
le to c
h
an
g
e at a
ny ti
m
e a
n
d w
ith
ou
t o
b
lig
ati
on o
n C
A
M
E c
an
ce
lli
auto
m
ati
ci
s.p.a. to n
otify u
se
rs.
ENGLISH
The ZL180 is calibrated to the F7024N or A3024N commands for gate leaves of up to 3 meters.
To command A5024N models (with gate leaves of over 3 m ) and reduce peripheral speed, do the
following:
a) - Set dip switches 1 and 6 to ON (and dip switches 2, 3, 4, 5 to OFF);
b) - press CH1: the red PROG led will start to blink;
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the
functions selection, see paragraph 7, page 12).
N.B.: to return to default, follow the same procedure while pressing CH2.
default
CH2 = A3024N
F7024N
G
E
A
R
MO
T
OR
S
C
ONNE
C
T
ION
OP
T
ION
S
The control panel is set for 2 gearmotors (2 leaved gates).
With only one gearmotor (one-leaved gates; M2 gearmotor), do the following:
he following:
a
a) - Set
) - Set dip switches 4 and 6 to ON
dip switches 4 and 6 to ON (and dip switches 1, 2, 3, 5 to OFF);;
b) - press CH1: the red PROG led will start to blink;
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the
functions selection, see paragraph 7, page 12).
N.B.: to return to default, follow the same procedure while pressing CH2.
CH1 = 1 gate leaf
default
CH2 = 2 gate leaves
CH2 = Opening slowdown
default CH1 = Opening stop
The microswitches on RA terminals, set the opening stop by default.
If you want instead the slowdown in opening is compulsory setback mechanics,
follow these steps:
a) - Set dip switches 5 and 6 to ON (and dip switches 1, 2, 3, 4 to OFF);;
b) - press CH2: the red PROG led will start to blink;
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which
depends on the functions selection, see paragraph 7, page 12).
N.B.: to return to default, follow the same procedure while pressing CH1.