Cameo ARA User Manual - page 20
20
IR REMOTE CONTROL / IR FERNBEDIENUNG / TÉLÉCOMMANDE INFRAROUGE / MANDO A
DISTANCIA POR INFRARROJOS / PILOT NA PODCZERWIEŃ / TELECOMANDO A INFRAROSSI
EN
Point the infrared remote control directly at the infrared sensor installed on the front of the spotlight. The maximum range is
about 8 metres. If the beam effect is operated in the DMX or Slave modes, the functions on the remote control are disabled.
Black
Out
On/Off
Press the blackout button to activate the sleep mode on the beam effect (the effect LED is off, the display will show
"OFF"). Press the blackout button again to return to the previously activated operating mode.
Auto
Auto-
Program
The colour change programs Pr00 to Pr10 can be activated by pressing the AUTO button (Pr00). Now you can directly
select the programs Pr01 to Pr10 using buttons 1 to 0. The Jump button
Jump
allows you to select the Auto Programs
Pr01 to Pr16 by scrolling up through the numbers; the Fade button
Fade
to select the Auto Programs Pr17 and Pr18 (fading
programs). The program running speed can be adjusted using the
+
and
-
buttons in eight increments.
Sound
Music
Control
The Music control programs Pr00 to Pr16 can be activated by pressing the Sound button (Pr00). By repeatedly pressing the
Sound button, you can select the programs Pr00 to Pr16 by scrolling up through the numbers; the Programs Pr00 to pr09
can be directly activated using the buttons 0 to 9. To adjust the sensitivity with which the beam effect responds to sounds
(bass pulses), press the
+
and
-
buttons in eight increments.
DMX
DMX
Control
To activate the DMX mode, press the DMX button; the DMX address can be set as desired using the
+
and
-
buttons
(A001 - A512). If you press the DMX button again, the DMX address can also be set using the
+
and
-
buttons (CH02,
CH03, CH04, CH08, please follow the display).
Red
Green
Blue
Amber
Static
colours
Press one of the colour buttons to activate the corresponding LEDs (only 1 colour
possible). You can also activate a strobe effect by pressing the Flash button
Flash
and
adjust the strobe frequency from slow to fast in 4 increments using the
+
and
-
buttons. Pressing the Flash button again stops the strobe effect.
Color
Static
colours
Repeatedly press the Colour button, if necessary, to activate the desired colour LEDs (only 1 colour possible). You can also
activate a strobe effect by pressing the Flash button
Flash
and adjust the strobe frequency from slow to fast in 4 increments
using the
+
and
-
buttons. Pressing the Flash button again stops the strobe effect.
The numeric buttons 0 to 9 are used to directly select the program in the Auto program and Music control operating
modes.
+
-
The plus and minus buttons allow you to adjust the program speed, microphone sensitivity, stroboscope frequency, as well
as the DMX address and the DMX mode in the corresponding operating mode.