Cameo CLNSCAN100 User Manual - page 5
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
5
DMX
CONNECTIONS, CONTROLS AND INDICATORS
POWER OUT
MAX: 3A
FUSE: F3AL/250 V
100V-240 V AC, 50/60 HZ
Power Consumption: 25 W
DMX OUT
DMX IN
MODE
ENTER
UP
DOWN
4
3
7
2
1
6
5
1
POWER IN
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery.
IMPORTANT INFORMATION: Always replace the fuse only with a fuse of the same type with the same rating (printed on the device). If the
fuse blows repeatedly, please contact an authorised service centre.
2
POWER OUT
IEC mains output socket. Used to supply power to additional CAMEO spotlights. Make sure that the total current consumption in amperes (A)
of all connected devices does not exceed the specified value on the device.
3
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
4
DMX OUT
3-pin female XLR socket for looping through the DMX control signal.
5
LED DISPLAY
The four-digit LED display indicates the operating mode and other system information.
6
CONTROL BUTTONS
MODE: Selecting the main menu items. To access a higher level in the menu structure.
ENTER: Confirm program selection and value changes.
UP and DOWN: Selecting an operating mode, system settings and programs, e.g. changing the program speed and DMX address.
7
SAFETY EYELET
Safety eyelet for safety rope. Overhead installation should only be carried out by trained personnel. The projector must be secured with an
appropriate safety cable to prevent falling.
NOTE: The lens for focussing the projection at various distances is located in the housing. The knurled frame provides for a better grip
(clockwise rotation = remote range, counter-clockwise rotation = close range).
The microphone for the music control mode is located next to the focussing lens.