Cameo CLNSCAN100 User Manual - page 7
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
7
DMX
SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust or read system settings and information, press the MODE button repeatedly until "SEtt" appears on the display. Confirm with
ENTER. Now you can select and modify one of the following menu items using the UP and DOWN buttons:
UP/DOWN
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
-> ENTER ->
<- MODE
Display is
rotated by180°
(overhead mounting)
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
on = display always on
off = display goes off after
approx. 60 seconds of inactivity
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
reversal of the PAN direction
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
reversal of the TILT direction
With this menu item, you can define
which operating mode should be enabled
when in the DMX mode,
the DMX signal is interrupted.
-> ENTER ->
<- MODE
UP/DOWN
-> ENTER
/
/
-> ENTER
<- MODE
Reset to
factory setting
-> ENTER
<- MODE
Displays the firmware
Version
Last DMX command
is held
Blackout
Auto Program
MOUNTING
Mounting on a truss is performed using the supplied adjustable mounting bracket and a suitable truss clamp (not included). The device must
be secured with an appropriate safety rope to the safety eyelet.
NOTE: Overhead installation should only be carried out by trained personnel.