Cameo CLPFLATPRO12 User Manual - Operation:

OPERATION:

MUSIC CONTROL

Press the MODE button until "SOUND" appears in the upper line of the 

display. Now the projector is controlled by the built-in microphone and 

follows the beat of the music. To adjust the microphone sensitivity, press 

ENTER, and the cursor appears in the lower line of the display (SENS:xx) 

and use the UP and DOWN buttons to set the desired value from 00 to 31 

(SENS:00 = minimum sensitivity, SENS:31 = maximum sensitivity). Confirm 

with ENTER.

SELECTING DMX MODE

Press the MODE button repeatedly until "DMX MODE" appears in the upper 

line of the display. Press ENTER, and the cursor appears in the lower line 

of the display and then use the UP and DOWN buttons to select one of the 

five DMX modes (02CH, 03CH1, 03CH2, 05CH, 08CH). Confirm with ENTER. 

You will find tables with the channels of the different DMX modes on the 

following pages of this manual.

DMX START ADDRESS

Press the MODE button repeatedly until "DMX ADDR" appears in the upper 

line of the display. Press ENTER, and the cursor appears in the lower line 

of the display and then use the UP and DOWN buttons to select the desired 

DMX start address between 001 and 512. Confirm with ENTER.

NOTE: The illumination of the LC display switches off automatically after 

approx. 70 seconds of inactivity. Pressing any one of the 4 control buttons 

will turn the illumination of the LC display on again.

12

13

IT

ALIANO

POLSKI

ESP

AÑOL

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

DEUTSCH

ENGLISH