Cameo CLQR40 User Manual - page 15

Manual is about: 4-head barrel scanner RGBW

Page of 44

Download

Bookmark us

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO

A few seconds after connecting to the power supply, the projector is ready for operation and the operating mode that was previously selected

is activated.

SELECTING THE DMX START ADDRESS

Press the MODE button repeatedly until “Addr” appears on the display. Press ENTER, and while all four characters are flashing on the display, the

DMX start address can be set as desired using the UP and DOWN buttons (A001 - A512). Confirm the input with ENTER. The synchronous control of

multiple spotlights (same model) through a DMX control unit (e.g. DMX console) can be achieved by assigning the spotlights to an identical DMX start

address and DMX mode and connecting them using DMX cables.

UP/DOWN

-> ENTER ->

-> ENTER->

ADJUSTING THE OPERATING MODE

Press the MODE button repeatedly until “MOde” appears on the display. Press ENTER, and select the desired operating mode using the UP and

DOWN buttons (DMX 2Ch, 4Ch, 12Ch, 18Ch, SLAv, AUtO, SOun). Confirm the input with ENTER. You will find tables with the channels of the different

DMX modes on the following pages of this manual.

UP/DOWN

-> ENTER->

-> ENTER

SLAVE MODE

Connect the slave and the master unit (same model) with a DMX cable and activate one of the standalone modes (AUTO, SOUND) on the master unit.

Now the slave unit follows the master unit.

AUTOMATIC CONTROL MODE (AUTO)

Select one of the 16 different auto programs (AUt1 - AU16) and the time factor (SP00 - SP99) of the LED and barrel scenes (value SP16 = scene du-

ration approximately 1 second, SP00 = factor 0.1, SP99 = factor of 10. The higher the value, the longer the period of time until the scene changes).

UP/DOWN

-> ENTER->

UP/DOWN

-> ENTER

UP/DOWN

-> ENTER

-> ENTER ->

MUSIC CONTROL MODE (SOUND)

Select the Music control mode, to control the effects spotlight via the built-in microphone (bass pulses). Select of the 16 different sound programs

(SOU1 - SO16) and select the desired microphone sensitivity (Se01 - Se99) as desired (Se01 = minimum sensitivity; Se99 = maximum sensitivity).

UP/DOWN

-> ENTER->

UP/DOWN

-> ENTER

UP/DOWN

-> ENTER

-> ENTER ->