Cameo CLZB60BLSD User Manual - page 11
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
11
DMX
AC Failure
= Operating status with mains fault
No Action
Lamp switches to battery operation in
the same operating mode
Blackout
Lamp changes to blackout
Emergency Light
Lamp changes to colour macro "Cold
White" with battery operation
Dimmer Curve
= Dimmer curve
Linear
Light intensity increases linearly with
DMX value
Exponential
Light intensity can be finely adjusted at
lower DMX values and broadly adjusted
at higher DMX values.
Logarithmic
Light intensity can be broadly adjusted
at lower DMX values and finely adjust-
ed at higher DMX values.
S-Curve
Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
Dimmer Response
= Dimmer sensitivity
LED
Lamp responds abruptly to changes in
DMX value
Halogen
Lamp behaves like a halogen spotlight
with soft brightness changes
Color Calibration
= Colour calibration
Red, Green, Blue,
White
Individual colour calibration. Cross-
mode brightness setting of the 4
LED groups RGBW with values from
000 - 255
Autolock
= Automatic locking of the controls
On
Automatic locking of the controls after
approximately 1 minute of inactivity.
Display in the display after the operat-
ing test: “Locked!”
To unlock: Press and hold UP and
DOWN simultaneously for approx. 5
seconds
Off
Automatic locking of the controls is
disabled
IR Remote
= Activates / deactivates functionality of IR
remote control
On
Functionality is activated
Off
Functionality is deactivated
Wireless Setting
= W-DMX settings
(Wireless-DMX)
Receive On/Off
On = W-DMX enabled
Off = W-DMX disabled
Receive Reset
No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
Factory Reset
= Reset to factory setting
Reset to factory settings:
ENTER -> “Reset Now!” -> ENTER
Confirm all entries with ENTER.
linear
DMX value
Light intensity
exponential
DMX value
Light intensity
logarithmic
DMX value
Light intensity
S-curve
DMX value
Light intensity
DIMMER CURVES
BATTERY RUNTIME
The battery runtime can be extended to up to 24 hours by reducing the brightness (see Settings table). Here runtime is calculated based on
Full On and 100% battery charge status. Runtime is significantly extended when not all colours – red, green, blue and white – are activated
(Full On) but only, for example, red.