Cameo CLZB60BLSD User Manual - page 12

12

DEUTSCH

FRANCAIS

ESP

AÑOL

ENGLISH

IT

ALIANO

POLSKI

DMX

MANUAL LOCKING  FUNCTION

In addition to the ability to protect the lamp automatically from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the 

controls can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt 

is made to change settings, "Locked!" will appear in the display and changing the lamp’s settings via the controls is no longer possible. 

After approx. 1 minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously 

for approximately 5 seconds. 

The display will show the previously displayed information.

IR REMOTE CONTROL

BLAC K

OUT                      AUTO

SOUN D

STROBE                       

SPEED                       

SENS I

TIVITY                  

-

3                      

2                      

1                      

4                      

5                      

6                      

9                      

8                      

7                      

-                      

+ 

FADE

R                      

G                      

B                     

W                     

A                      

%                      

MANUAL

0                      

UV              

Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The maximum 

range is approximately 8 metres. In DMX and Slave modes, the remote control is deactivated. Battery 

for IR remote control = CR2025.

Blackout

The blackout button is used to switch off all LEDs, regard-

less of operating mode enabled via the remote control. 

Press the blackout button again to reactivate the previously 

selected mode. 

Auto-programme

Auto-Programmes 1 - 6. Programme selection with 

and 

. Programme run speed with 

and 

and

. Brightness setting with

and

and

.

No function.

Strobe

Strobe light for AUTO, FADE and MANUAL operating modes. 

Press 

to activate. Strobe speed with

and

. 

Press

to deactivate strobe.

Speed

Setting the running speed for Auto and Fade programmes.

No function.

Brightness

Press

and

and

to adjust brightness.

Manual colour mix

Press

and

,

,

or 

to manually mix 

colours. Adjust intensity with

and

.

SYSTEM INFORMATION (System Info)

Press MODE to access the device settings selection menu (--- Menu ---). Using the arrow keys, select the menu item "System Info" 

(observe arrow) and confirm with ENTER. 

------------------- Menu -------------------

 Mode

 Settings

 System Info

Use the UP and DOWN controls to select the desired sub-menu item, and press ENTER to display the corresponding information.

System Info

Firmware

=

Displays device firmware

Main CPU

Vx.x

Temperature

=

Displays temperature of LED unit

LED Temp

xx°C / xx°F

Unit

°C (= display in degrees Celsius)

°F (= display in degrees Fahrenheit)

Operation Hours

=

Displays operating time

xx:xx h

Displays total operating time in hours and minutes