Cameo MATRIX 100 W User Manual - page 16
16
MIRRORED DISPLAY
With this function, letters, numbers and symbols can be displayed horizontally or vertically or mirrored horizontally or vertically on the LED matrix
panel. Press the MODE button repeatedly until “Inve” appears on the display and confirm by pressing ENTER. Using the UP and DOWN buttons, select
the desired option and confirm with ENTER.
UP/DOWN
-> ENTER->
-> ENTER
Mirroring
disabled
horizontal
Mirroring
vertical
Mirroring
horizontal and
vertical mirroring
SYSTEM SETTINGS AND SYSTEM INFORMATION
To be able to adjust or read system settings and information, press the MODE button repeatedly until “Sett” appears on the display. Confirm with
ENTER. Now you can select and modify one of the following menu items using the UP and DOWN buttons:
-> ENTER ->
UP/DOWN
-> ENTER
-> ENTER ->
UP/DOWN
Display is rotated
by 180°
(overhead mounting)
-> ENTER
-> ENTER ->
UP/DOWN
on = display always on
off = display goes off
after about 60 seconds of
inactivity
-> ENTER ->
UP/DOWN
Using this menu item, you can define which
mode is to be activated, should the DMX
input signal be lost in the DMX mode.
-> ENTER
last DMX command
is held
Blackout
Music control
-> ENTER ->
UP/DOWN
Setting the
Dimmer curve
Dimmer curve
linear
The light intensity
increases linearly
with the DMX value.
Dimmer curve
exponential
Adjustment of the
light intensity is
finer in the lower
DMX value range
and coarser in the
upper DMX value
range.
Dimmer curve
logarithmic
Adjustment of the
light intensity is
coarser in the lower
DMX value range
and finer in the
upper DMX value
range.
-> ENTER
S-curve
Adjustment of the
light intensity is fine
in the lower and
upper DMX value
ranges and coarse
in the middle DMX
value range.
-> ENTER
-> ENTER ->
UP/DOWN
Dimmer response
The light reacts
abruptly to changes
in the DMX value.
The light behaves
in a manner
similar to that of a
halogen lamp with
gentle changes in
brightness.
-> ENTER ->
displays the
firmware version
-> ENTER ->
Displays the device
temperature in °C
-> ENTER ->
Displays the operat-
ing time in hours
-> ENTER ->
LED Test
Functional test of all
LEDs from 1 to 25.
Display flashes
during test. Press
MODE or ENTER
to exit.