Camon important please read carefully operator manual c500 stump grinder teknol house, victoria road, burgess hill rh15 9lh t: 01444 247689 f: 01444 871612 i: www.Tracmaster.Co.Uk.
C500 stump grinder operation operation before operating, please consult the safety section for vital information relating to the operation of this powerful machine. Warning ! Know your machine general identification 3 6 4 5 1 8 9 7 2 (1) operator presence control (2) handlebar (3) engine (4) cutter ...
Operation warning ! Transporting the machine the c500 is designed to be transported via a van or small trailer. The machine is equipped with grab bars that are to be used for both lifting the machine, and strapping it down. This machine weighs approximately 118kg and should only be lifted by a minum...
Operation warning ! Removing stumps before operating, please carefully review the safety section for vital information relating to the operation of this powerful machine! Notice remove all loose pieces of wood, stones, wire and other debris from the work area before beginning stump removal. Wind dir...
Operation warning ! Procedure for cutting a stump never leave controls when cutting wheel is rotating! 1. Prepare machine at stump ! Place machine into position with cutting wheel near top edge of stump. Notice before operating the c500, review machine controls presented earlier in this operation se...
Operation procedure for cutting a stump (continued) 3. Cut stump proper ! Make sure the throttle is set to “fast”. The cutter wheel is thus accelerated to cutting speed. ! Direct the cutter wheel against the stump, beginning with the nearside top corner of the stump, and steadily sweep it across the...
Operation machine stopping 1. When stopping the machine after normal operation, lower engine speed to “slow”, and release operator presence control. A rotating cutting wheel is very dangerous! Stand at controls and ensure that cutting wheel comes to a complete stop before doing anything else. 2. Set...
Safety while in operation 1. Know how to shut the machine off in an emergency. 2. The operator must never leave the controls while the machine is in operation. 3. Never let clothing, long hair, jewelry, etc hang loosely. It is possible that they can become dangerously entangled in the moving parts o...
Safety normal shutdown procedure in consideration of your own safety as well as that of others, you should always use the following normal shutdown procedures before departing from the controls for any reason, including cleaning, servicing, transporting, or inspecting the stump grinder. Never deviat...
Safety before starting the engine 1. Review all of the safety decals that are placed on the machine for your safety and convenience. See parts section for aid in locating all decals on the machine. 2. Make sure that all shields, guards, and curtains are in place, and are in good condition prior to o...
