Camp Chef SmokePro PG24SE Warning & Instruction Booklet - page 6
FIG. 5
3. Assemble the wire shelf to the legs as shown in Fig 2 using
Qty (4) M6 x 45 Bolts, Qty (4) M6 Flat Washers, Qty (4) M6
Lock Washers, and Qty (4) M6 Nuts. Finger tighten hardware.
4. Assemble Qty (2) Wheels to the legs as shown in Fig 3
using Qty (2) Wheel Axles, Qty (2) M8 Flat Washers, and Qty
(2) M8 Nyloc Nuts. Tighten axle hardware with a wrench.
5. With the help of another person stand the grill upright. Be
careful as the lid on the hopper and grill will close as the
grill is stood upright.
6. Tighten all hardware assembled in the previous steps. Do
not crush the tubes by over tightening hardware.
INSTALL HANDLE
1. Install the handle as shown in figure 4.
2. Tighten all hardware.
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 5.
INSTALL DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip tray as shown
in Fig. 6 and Fig. 7.
FIG. 6
FIG. 2
FIG. 4
M6 NUT (2)
M6 LOCK WASHER (2)
M6 FLAT WASHER (2)
M6 FLAT WASHER
M6 X 45 BOLT
M6 X 45 BOLT
M6 LOCK WASHER
M6 NUT
M6 FLAT WASHER
M6 LOCK WASHER
M6 NUT
GREASE BUCKET
M8 FLAT WASHER
M8 NYLOC NUT
WHEEL AXLE
FIG. 3
HEAT DEFLECTOR
DRIP TRAY
HEAT DEFLECTOR
DRIP TRAY
FIG. 7