Campbell CR9000X Instruction Manual - page 17
Overview
OV-13
RealTime
Alarms List
Allows the display of up to 20 fields from a single data table. Two alarm
conditions can be created for each field by double clicking the left mouse
button while the cursor is held over the field number. After the alarm
parameters are set-up, they can be saved to and subsequently loaded from an
.alm file. The .alm file can be edited using the program editor.
Field Monitor
Allows the display of up to three different tables at a time. Each table module
may display any of the available fields from any of the available tables.
Virtual Meter
Allows the display of up to five different meters at a time. Each meter may
display any of the available fields from any of the available tables. Each meter
may be independently ranged and scaled as desired. In addition, each meter
may have two independent alarms that are visual and/or audible as desired.
Each meter may be displayed as a vertical or horizontal bar graph or as an
analog gauge. If Cal-On-Site is selected from the Program Generator, each
meter can provide access to the sensor calibration facility.
Trend Monitor
Allows the display of up to 20 different traces on a single trend or strip chart.
Each trace may display any of the available fields from any of the available
tables. You can invoke multiple iterations of the Trend Chart window for
viewing additional variable traces.
Virtual Oscilloscope
Allows the display of up to 20 different traces on a single scope. Each trace
may display any of the available fields from any of the available tables. You
can invoke multiple iterations of the Virtual O’Scope window for viewing
additional variable traces.
X-Y Plotter
Allows the plotting of 20 different fields against one field from the same table
in an X-Y configuration. You can invoke multiple iterations of the XY Plot
window.
Spatial Plot
Allows the display of values from multiple fields in a Trend plot. Useful for
displaying data from various sensors in a histogram format. Can also be used
to pick a selection of bins from a histogram or FFT to display. You can invoke
multiple iterations of the Spatial Plot window.
Basic 2-D Histogram
Allows the display of two-dimensional histograms in real-time. You can
invoke multiple iterations of the Histogram window. An understanding of the
Histogram instruction for the data logger is required to make use of this
window.