Campbell Hausfeld HVLP Operating Instructions & Parts Manual

Manual is about: Campbell Hausfeld Spray Gun Operating Instructions & Parts Manual

Summary of HVLP

  • Page 1

    Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Reta...

  • Page 2

    Figure 2 - thin material needle and nozzle kit 3. The all purpose material needle and noz zle have three groove rings as shown in figure 3 below. Figure 3 - all purpose material needle and nozzle kit 2 operating instructions and parts manual hazardous vapors: paints, solvents, insecticides, and othe...

  • Page 3

    3 operating instructions and parts manual 6. Install the appropriate needle/nozzle assembly se lect ed for the material to be sprayed (fig. 2, 3 & 4 ). 7. Reassemble the needle assembly, spring, ma te ri al con trol knob, nozzle, air cap, and retainer ring. Adjusting packing occasionally the packing...

  • Page 4

    4 operating instructions and parts manual 6. Attach the air hose quick-connect fitting to the gun. The quick-connect notice fitting outer sleeve is spring load ed and must be pulled back to attach or remove it from the gun (see figure 10). Figure 10 - attaching the air hose operation always practice...

  • Page 5

    5 3. Place the parts and the paint cup in a bucket or other suitable container. Soak the parts in a suitable solvent, or in soap and water if latex was used (see figure 16). To clean the gun, flush a suitable cleaning solvent through the material tube until the so lu tion begins to clear. Repeat the...

  • Page 6

    6 operating instructions and parts manual no material flow slow material flow material leak spray will not shut off pulsating spray excessive overspray 1. Dis as sem ble and clean 2. Dis as sem ble and clean (a straight pin can be used to clean fittings) 3. Dis as sem ble and clean 4. Disassemble an...

  • Page 7

    7 troubleshooting chart symptom possible cause(s) corrective action spray not uniform (spitting) poor pattern overheating poor air flow spray tip clogs 1. Check ma te ri al viscosity (thin per instructions) 2. Change to prop er needle/nozzle 3. Tighten cup, replace seal or check valve 4. Adjust or r...

  • Page 8: Call 1-800-626-4401

    8 operating instructions and parts manual for replacement parts, or technical assistance, call 1-800-626-4401 please provide following information: -model number -serial number (if any) -part descriptions and number as shown in parts list 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 2...

  • Page 9

    ■canister assembly (includes items 2-4) sk205800aj 1 ✦trigger assembly (includes items 9-11 & 22) sk206100aj 1 ▲air flow control knob assembly (includes items 12, 19-21) sk206200aj 1 ❉ gun body assembly (as shown, includes 9-13, & 16-24) sk600000aj 1 note: air cap kit includes #5, 6 & 8 air cap only...

  • Page 10

    10 operating instructions and parts manual limited warranty 1. Duration: from the date of purchase by the original purchaser as follows: standard duty paint application systems and all paint application accessories - 1 year, serious duty paint application systems - 3 years, extreme duty paint applic...