Campbell RWIS STATIONS Instruction Manual - page 8
RWIS Stations
4
NL110 Setup
NL100/105:
TLink config: [RS232]
RS485 config: [disabled]
CS I/O config: [PakBus]
CS I/O SdcAddr/bps: [SDC7]
CS I/O beacon interval (sec): [60]
RS232 config: [PPP]
RS232 bps: [38k]
EtherNet 10BASE-T: [enabled]
10BASE-T port IP address: [192.168.7.53]
10BASE-T port network mask: [255.255.255.0]
Is there a default gatway: [no]
PakBus node Id: [678]
Clock neighbor node Id: [1]
PakTcp server config: [enabled]
PakTcp server port number: [4001]
PakTcp client config: [disabled]
Configuration monitor telnet port: [23]
Telnet session password: [nl100]
Serial server watchdog (minutes): [2]
Power Saving Mode: [disabled]
MODBUS/TCP gateway config: [disabled]
SNMP Version 2: [enabled]
Logger ID for PakBus: [1]
PMPP PC Address: [50]
Network Address for PPP: [192.168.18.150]
Network Mask for PPP: [255.255.248.0]
PPP Password (Max. 8 characters): [ntcip]
Enable Ethernet Port: [enabled]
Set Modem Answer Rings (1: default): [1]
Modem Initialization: [AT]
NL100/105 (ver, last, curr, show, edit, defaults, reset, help, bye):