Camsat CD06 Instruction Manual

Summary of CD06

  • Page 1

    Camsat www.Camsat.Com cd06 transmitter and receiver this set is used for remote control (turn on/off) by means of any devices for long distance. It uses the rs485 wire interface. The cd06-rx receiver possesses six transmitters in it, of the current load up to 4a each. The no (normally open) contact ...

  • Page 2

    Characteristic features of the cd06 set: • communication between transmitters and receivers of the rs485 standard (with the speed of 2400bps or 9600bps), on the basis of the pelco-d protocol; • a possibility of communicating in the one-way mode (without confirmation) or in two-way mode (with confirm...

  • Page 3

    Co-operation of the cd06rx receiver with the ptz keyboard. The cd06-rx receiver can be controlled by means of any ptz keyboard with the pelco-d 2400 and 9600 protocol. The following ptz keyboard keys are used in this purpose: zoom+, zoom-, focus+, focus- and iris+, iris-. Each of these keys controls...

  • Page 4

    Permitted connections of several cd06 sets one-way transmission: a) 1 transmitter controlling maximum 32 receivers of the same address b) maximum 32 transmitters controlling 32 receivers of the same id address* c) maximum 8 transmitters controlling 8 receivers of different id addresses* d) 1 transmi...

  • Page 5

    Remarks: the final reading of settings takes place after resetting the set, thus after each change of settings, it is necessary to reset both devices. It can be realised by changing the pin8 state or by disconnecting the device from the power supply and connecting it once again. Things to keep in mi...

  • Page 6

    General terms and conditions of a warranty camsat company gives a warranty of 24 months for transmission sets of the following series: tco 5807, cam 5816, cds 5021, cd04, cd06, cds-5ip 1. In case of detecting incorrect work of a device, before giving the device to the service, it is necessary to mak...