Camsat CD06 Instruction Manual - page 5
REMARKS:
The final reading of settings takes place after resetting the set, thus after each change of
settings, it is necessary to reset both devices. It can be realised by changing the PIN8 state or
by disconnecting the device from the power supply and connecting it once again.
Things to keep in mind while designing networks with CD06 devices in order to avoid errors
in their functioning:
•
only one transmitter of a given ID address can be connected to one RS-
network in the two-way transmission;
•
the transmitter can control up to 32 receivers only in a one-way mode, in two-
way mode, the control in a two-way mode takes place only in the following
way: one transmitter -> one receiver or one transmitter -> two receivers of
different ID addresses;
•
while controlling receivers by means of the PTZ keyboard, it is necessary to
remember to turn off the two-way mode and to turn on the bistable mode in
the receiver;
•
it is not possible to control the CD06 transmitter and the PTZ keyboard by
means of one receiver;
•
the transmitter’s inlets have mass on one of outlets, so it is not possible to
connect a different potential from the same power supply adaptor in this
place.
FAQ
•
Each time I turn the power supply of the transmitter on, the outlet state is changed for an
opposite one! Most probably a bistable mode and a continuously closed outlet in the
transmitter are chosen. In the bistable mode, the transmitter’s inlet should be controlled by
the growing “impulse” that is (a change in the state: closing / opening) and not a continuous
closing of the inlet. Verify the correctness of SETTINGS in the CD06-Rx - PIN5 and PIN6
receiver.
•
Apart from the correct connection of RS wires, the devices do not communicate with one
another. Check if the changes in the statesof inlets cause light in the TxD transmitter’s
indicator and the RxD receiver. Check the transmission speed settings – it should be the same
in both co-operating devices.
•
The POWER indicating light does not work. Check the correctness of the supply wire
connection, the level of this voltage and polarity. The scope of voltage: 10-14V DC.
•
The control takes place in a chaotic way and is not in accordance with the transmitter’s
control. Reset the EEPROM memory by means of turning on and off the DIP8 switch in the
transmitter or the receiver. Check whether the RESPONSE DIP8 switch in both devices is set
in the same way. In case of using the advanced functions and starting transmission
confirmations, it is required to have the function switched on in both devices (in transmitters
and receivers).
•
After the control of the transmitter, indicators start to blink. most probably, the function of
two-way RESPONSE PIN8-ON was turned on in the transmitter and the receiver does not
respond or has this function turned off. Check the correctness of settings and connections of
RS485 wires.
A longer description of the device with detailed descriptions of all functions and exemplary
connections can be found on the following website: www.camsat.com.pl
Manufacturer:
CAMSAT Gralak Przemysław
ul. Ogrodowa 2a
86-050 Solec Kujawski
Offer and information: www.camsat.com.pl
Service: serwis@camsat.com.pl