Camtrol Video Camera Stabilizing Quadpod User Manual - page 6
Follow set up instructions #1-12 if using a wired LANC or other manufacturer’s
wired remote controller. If not using a wired remote controller, go to step #13.
Set Up Instructions
1)
Using a Phillips screw driver, remove two screws on either side of ACG. Set aside
for use in a later step.
2)
After screws are removed, slide out RP/RA. Set aside for use in a later step.
3)
With your finger, or small blunt object carefully remove Protective Cable Cover
(PCC) by peeling out from the bottom. Set aside for use in a later step.
Camtrol Video Camera Stabilizing Quadpod User’s Manual
5
Figure 2 Removal of Camtrol Remote/Accessory Receiver Post
E- Set Up Instructions For Installing Wired Remote Controllers
Continued on next page….
2. Remove
RP/RA
1. Remove 2 screws
3. Carefully peel
PCC from this end